Видео

I live in high country where we experience freezing. Shark bites will release when the pipe freezes and separate, the teeth do not hold when the two pieces of pipe are expanded with the water freezing. There are some tests on you tube showing this problem. I would only use them in an emergency TEMPORARY repair.

Amen to that. I did residential service for like a year and a half and then switched over to commercial new construction and found that I love the construction environment and I’ve been there ever since.

I can't imagine how much this job cost. Neighbors had something like this happen and just walked away from it. Was known to the next buyers of the house and it still sold 80K over asking. Crazy. No insurance coverage. Job cost 30K to repair the pipes that were 8FT below ground and 40 feet out. Relining them was easier but 45K.

Really funny skit! I used some of those Fernco Pro couplings to properly convert from copper waste pipe to PVC for toilet, laundry and sink- it's a really nice coupling and I can highly recommend it for DIY. As long as the pipe ends are cut square and deburred, you can be comfortable with sealing them back up in the wall.

Straight MEK and PVC shavings can make a great PVC repair compound that solvent welds itself vs epoxy sticks.

Funny Roger, Who's the guy smoking a glue joint???

Bs it's all online so screw you

"Exsellent Plumbing" lol

My coworker who was a licensed plumber was using sharkbite fittings when he was attempting to fix my leak. Our issue is the sharkbite did leak and we tried to release the fitting. They would not come apart. He cleaned it but we could not get it apart to recheck the pipe. I was skeptical about pro press fittings but you proved that they are reliable if done right.

WHO freaking buys coke to clean toilet though?

Or you could crank the thermostat

2 years and you can do single dwelling on your own , and insured , wish it was like that in Canada 🇨🇦 🛠️ 🤘

Don’t walk on the piping Roger

Braze, solder, lead & oakum, and weld pipe for plumbing... Push to connect works well in the bedroom 😜🤣

Thank you

Laying out on the floor for overhead

lol entertaining thanks Roger for the information! Great content

I don’t care how expensive a camera is it it’s probably the fastest paying off tool I ever owned and I don’t do a lot of drain cleaning. It paid for its self within months

Great video Roger! Looking forward for the next one!!

This is the absolutely best plumbing explanation I've ever seen. You are a great teacher. I feel very prepared to take on this project! Subscribed!

Your instructions are clear, and concise. Very easy to follow! Thank you for the video.

760 low key cheap af

First of all, i love your channel. Long time follower. Stop video at 2min to write this. I have seen your previous videos testing sharkebite fittings. Glad to see a new video using there new "max" fittings, as I do sell this product at my supply chain. (Pace Supply) looking forward to see if sharkebite improved on their design. Also, because I dont recommend this product unless it is need for a "quick fix". Thank you.

This is hilarious!!

You been smoking the Oakum

This is just stupid

In michigan you have to have an apprentice license to work on any commercial stuff, i applied an got hired an they taught me how to get that card an gave me books on all the stuff i needed to know an told me theyd help me get to the point i can go take the exams an get licensed an more money

Roger, you must have been watching reruns of that 70's show!! Lol 😆

Very funny Roger!

Ive done them all... Oakum and lead, braze, welding for nitrogen purge on hydrogen furnaces, PEX A and B on and on.... I will never leave a shark bite on a job other than a temporary hose bib or temporary cap, and I refuse to install CPVC( I will make alterations or tap on to a existing system).

Yes

What’s that

S traps are NOT illegal.

How many feet of wire do you recommend for a rooftop auger? (I have a 25' foot hand-turn auger for the tub.) I'm in a single story home with what you referred to as a Low-Pitch Roof.

Sounds useful for trenching for fiber installation -- no more accidental telecom, electrical, or gas line cuts. We've had a bunch of those in my neighborhood with the internet access projects going on. My neighbors across the street were evacuated after the contractors cut right through their gas line. The rest of us were without internet for days after they chopped through a fiber cable that the older internet provider already had in the ground.

I got zero value from this video the dude talked about parking and what floor your gonna work on and lunch breaks… he knows nothing

In my opinion that is way too much flame on the oxy rosebud. Just a waste of gas and harder to control cherry red heat.

I'm currently a personal trainer/health coach. Been doing this for 5 years & feel time for a change. Watching your videos made me want to take a dive into plumbing. My wife going to school to be a teacher. I do 40-45 hours a week personal training. My question is there a possibility I can be a apprentice 2 days put the week or would I even have a opportunity since I won't be full time?

Just bought one with your link. Will take a month to get here but should be worth it. Thanks!

7:34 😂 sharkbites are strong

This video really helped me. Initially it wasn’t working. Then I rewatched it to the end this time (😂) where you said that the disposal was strong and could handle a lot of pressure. I went back it, and really pushed on the blades. BOOM!! It worked!!! Thank you so much 😊

Hi mate Can you tell us why math is necessry in plumping

Pure lye will eat through your house and the ground like the Chernobyl elephants foot. 😂

Whats your view of rubber gasket vs. plumbers putty?